Ebasto Thermo Top TTC, Руководство по эксплуатации

Страница: 12 / 50

2 Operating the Heater Thermo Top (TTC)
2.6 SmarTemp Control fx / Operating instructions
Definitions Default
Time & Date Time & Date allows user to properly set the current date and time. User also has the ability to switch
between AM/PM and 24 hour modes. AM / PM
(12 Hour)
Mode Two modes are possible:
– Auto mode will allow the heater to turn ON/OFF based on the pre-defined timer programs.
Manual ON/OFF operation is still possible while in this mode.
– Manual Mode allows the heater to be manually operated via the Webasto button on the
SmarTemp Control fx. While in Manual Mode, all Auto Mode functionality is disabled (Timers
inactive).
Note: While in manual mode the heater will continue to operate based on the pre-defined
“Duration” set by the user. See “Duration” for further detail.
Manual
Duration Duration allows for the selection of timed heater run-time. Set range is between 10 – 120 minutes
selectable by 10 minute increments.
While using Manual Mode, the “Duration” setting will be used for the run-time of the heater when
the Webasto button is pressed.
60 minutes
Timer Timer allows the user to set 4 heater start-up cycles per day up to 7 days in advance. Select the day
or the specific timer program (T1 – T4) using the rotary knob and the selection button. Once the day,
time, and duration have been entered, press the selection button to set. A checkmark will confirm
the program has been saved. Each program can be edited or removed simply by selecting the box
again.
Note: Setting the Duration run-time (in the Duration section) before setting a timer program will
default all new programs to the user defined duration time.
No Presets
Skip The Skip feature looks similar to timer programming; however when a specific timer program is
selected, it will update the checkmark to an “s” for skipped. When a program has been skipped, it
will disable that specific timer program for one cycle (7 day period). Preset timer programming will
reactivate after this one-time skip cycle.
Note: To permanently remove a program, refer to the “Timer” section.
N/A
LVD
LVD “Low Voltage Disconnect” allows the user to adjust the battery voltage level at which the
Webasto SmarTemp Control fx will shut down heater functionality.
If battery voltage is equal to or less than the threshold se0.1v, the heater will not start. i.e. if
an 11.5v threshold is selected the heater cannot be started until B+ has reached 11.7v.
12 volt - Range between 11v – 12.5v
24 volt - Range between 21v – 25.5v
12.1v
24.2v
Error Codes This section will log the last 5 error codes and the date that it was set. Highlight and select an error
code for a full description.
If the heater produces an error code, the status indicator lights will flash red and the error will display
on the main screen. Error codes cannot be reset through the Webasto SmarTemp Control fx. Refer to
the heater service manual for resetting an error code.
Note: Error code functionality does not apply to Thermo Top C heaters. Errors codes for this product
can still be obtained using PC Diagnostics. Refer to the applicable service manual by visiting
www.techwebasto.com for detailed PC diagnostics information.
No Errors
Hour Meter
The hour meter logs the operating hours that the heater is commanded “ON” from the SmarTemp
Control fx.
Note: For warranty purposes a diagnostic printout is still required where applicable. This hour meter
is for reference only!
N/A
Default Default allows the user to perform a factory reset of the control settings and saved timer program
data. N/A
SW Version This displays the firmware version of the Webasto SmarTemp Control fx. Installed
Version
Back
Select this to return to the previous screen. N/A
Table 202: SmarTemp Control Setting Instructions
206