EBARA Ego Series, Руководство по эксплуатации и техническому обслуживанию, Страница: 26 / 116

GB
26
5.1.1.2 TURNING ON AND OFF
5.1.1.3 PUMP MODES AND PARAMETERS
5.1.1.4 SETTING THE PUMP TO THE FACTORY SETTINGS
When the pump is first connected it will operate with factory settings, which is “automatic mode”.
At each following start-up, the pump will operate with the last settings that were set prior to its last shut-down
To switch the pump off, press and hold the key for 5 seconds, until OFF is shown on the display. When the pump is
switched off, the OFF sign will remain visible on the numerical display.
To turn the pump on, press the key briefly.
To switch between modes, hold the key for 3 seconds and then select the desired operating mode with or keys.
Confirm the selection with the key.
After confirming the operating mode, the settable parameter will be automatically displayed and blinking (except for auto
mode). If necessary, set the parameter value with and keys then confirm the setting with the key or just press the
key to accept the given parameter.
To scroll through the parameters within a mode (W, m, m3/h, rpm) use and keys. Select the parameter that can be
modified (see individual mode) within a mode with the key and set the desired value with and keys. Confirm the
selected value with the key.
To restore factory settings to the pump, press and hold all three keys for 5 seconds. The pump will be set to the automatic
mode of operation. The previously set values for pressure and speed will be deleted.
There are two digital inputs available on the pump that has different functionality. Inputs can be set by Ethernet connection
on the settings page and overviewed on the overview page.
The relay output can be set by Ethernet connection on the settings page and overviewed on the overview page.
The relay output can be configured to:
To operate IO2, pumps 24V power supply can be used.
5.1.2 DIGITAL INPUTS
5.1.2 RELAY OUTPUT
Input Function Description
IO1
Run [Default] Start/stop pump
Max Sets pump to operate with maximum power
No function No function
IO2
Run Start/stop pump
Max [Default] Sets pump to operate with maximum power
Pressure switch Decreases RPM when active
No function No function