1
0
4
Water connection
• This appliance must be connected in compliance with any local or national
regulations or bylaws.
• To ensure your washing machine works correctly and to its optimum
performance the water supply pressure must be between 0.1MPa (1 bar)
and 1MPa (10 bar).
• Use the detachable water inlet hoses provided with the machine to
connect to the water supply never re-use an old hose set.
• If the supplied hoses (1.5m) are not long enough do not modify them to be
made longer. Replace then with new longer hoses.
• Do not use the washing machine if there is a leak! You are at risk of an
injury or an electric shock.
• Avoid over tightening that may damage the hose, causing the plastic screw
threads to be stripped.
• Always ensure the hoses are connected to the correct water supplies. The
hot supply should be connected to the right handside connector marked
red and the cold supply the the left handside connector marked blue.
Check each end of the
inlet hose to ensure the
black rubber seal is fitted.
Connect the L-shaped
inlet hose end to the back
of the machine.
Tighten by hand by turning
clockwise. Ensure the hose
is not twisted or kinked
before connecting the
other straight end of the
hose.
Connect the straight
end of the inlet hose to
the cold water supply
isolating valve. When
complete, open isolating
valve to let water into the
machine.
Check all connections for
no leaks.
1.
2.
3.
Cold fill machines
Getting started
