Eaton VORAD AlwaysAlert, Руководство по установке

Страница: 10 / 30

7
Component Installation
Recessed - Mounted to Bumper/Facia from behind through Cutout
Before drilling, check for any wiring, hoses and components that may be damaged by drilling and/or mounting
hardware.
1. Measure antenna assembly at centerline of bumper and cut out shape in bumper.
2. Determine which bracket configuration will work best and secure antenna assembly to bracket.
3. Install brackets to RV such that antenna assembly fits through cutout.
Selecting Hardware
When selecting the antenna assembly hardware, consider how the antenna wire harness is to be routed from the Central
Processing Unit to the antenna assembly. There must be room behind the antenna assembly for the antenna connector
to be attached to the rear of the antenna assembly. Care must be taken with the wiring harness, so it does not contact
sharp edges, moving or excessively hot parts.
After installation, align the antenna assembly (see Antenna Assembly Alignment on page 8).
1 - Support Rails (not supplied-fabricated by installer)
2 - Adjustment Screw (accessed from the rear) 3 - Antenna Assembly
4 - Cutout Hole
CAUTION
3
1
4
2