Eaton SPM 120, Инструкция по установке и эксплуатации

Страница: 19 / 32

13
System Parallel Module
Chapter 4 Installation
4 .1 Preliminary Installation Information
Refer to the following while installing the SPM:
• To review the SPM manual, Chapter 3 of this manual for cabinet dimensions, equipment weight, wiring and
installation notes.
• Do not tilt the cabinets more than ±10° during installation.
• Suitable for mounting on concrete or other non-combustible surfaces only.
1. If not already accomplished, use a forklift or pallet jack to move the SPM cabinet to the installation area, or
as close as possible, before unloading from the pallet. Insert the forklift or pallet jack forks between the
supports on the bottom of the pallet .
2. Remove four bolts securing the front shipping bracket to the cabinet and four bolts securing the bracket to
the pallet (see Figure 4-1). Remove the front shipping bracket. If installing the cabinet permanently, retain
the shipping bracket and securing hardware for later use.
3. Attach the ramp to the front of the pallet (see Figure 4-2):
a. Locate the ramp (top panel from wood container), ramp extension, and ramp brackets with M10
bolts.
b. Place the ramp against the front of the pallet.
c. Attach the ramp extension to the front of the ramp by inserting the tabs on the extension into
the slots at the bottom of the ramp.
4. If the leveling feet are not fully retracted, turn the leveling feet until they are retracted.
5. Remove four bolts securing the rear shipping bracket to the cabinet and four bolts securing the bracket to
the pallet (see Figure 4-3). Remove the rear shipping bracket. If installing the cabinet permanently, retain
the shipping bracket and securing hardware for later use.
WARNING
Wires enter/out can from the bottom, top and rear holes of cabinet.
4 .2 Unloading the SPm Cabinet from the Pallet
The SPM is bolted to a wooden pallet supported by wood skids.
WARNING
The SPM cabinet is heavy (see Table 3-1). If unpacking and unloading instructions are not closely
followed, the cabinet may tip and cause serious injury.
CAUTION
• Do not tilt cabinet more than 10° from vertical.
• Lift the cabinets only with a forklift or damage may occur.
The SPM uses inline wheels, not swivel casters. When moving the SPM, move the
cabinet in straight lines as much as possible, minimizing turns.
For the following steps, verify that the forklift or pallet jack is rated to handle the
weight of the cabinet (see Table 3-1 for cabinet weight).
NOTE