3 Installation
3.2 Mounting
DX-NET-SWD...
08/14 MN04012009Z-EN
www.eaton.com
23
3.2.2 Dismantling of DX-NET-SWD1
To remove a DX-NET-SWD1 interface module from a variable frequency
drive:
▶
Use a screwdriver (just like for installation) to remove the front plate
(on devices with an IP55 degree of protection only)
▶
Loosen the two screws on the module in order to release the locking
mechanism. Then pull the module out from the slot.
Figure 15:Removing a DX-NET-SWD1 interface module (left: IP20, right: IP55)
T 8
0.25 Nm
(2.21 lb-in)
COM
Ready
1 2 3 4 5 6 7 8 9 10 11 12 13
14 15 16 17 18
L1 L2 L3
+DC BR -DC
U V W
COM
T 8
0.25 Nm
(2.21 lb-in)
2
1
Содержание Power XL SmartWire-DT DX-NET-SWD Series
Страница 4: ...II ...
Страница 10: ...0 About this Manual 0 7 Units of measurement 6 DX NET SWD 08 14 MN04012009Z EN www eaton com ...
Страница 32: ...3 Installation 3 3 Install SmartWire DT connection 28 DX NET SWD 08 14 MN04012009Z EN www eaton com ...
Страница 92: ...4 Commissioning 4 6 SmartWire DT diagnostics 88 DX NET SWD 08 14 MN04012009Z EN www eaton com ...