6
5. Installation
Standard Rack-mounting
1
Slide out the rear mounting brackets from the console and mount both brackets (separate
from the console) to the inside rear of a standard 1U rack system using user-supplied
screws.
2
Take the console and gently slide it into the two rear-mounted brackets in the rack and
secure the console in place by inserting user-supplied screws.
2-Post Rack-mounting
The NetDirector Console KVM Switch can also be mounted in a 2-post rack installation using the
optional 2-Post Rack-mount Kit (model #: B019-000). The mounting hardware allows for the
console to be opened with the drawer in any position. Heavy-duty, 14-gauge steel provides
stability and prevents the console frame from twisting. See the B019-000 instructional manual
for detailed mounting instructions.
• If the following conditions occur, unplug the device from the wall outlet and bring it to qualified service personnel for repair:
o The power cord or plug has become damaged or frayed
o Liquid has been spilled into the device
o The device has been exposed to rain or water
o The device has been dropped, or the cabinet has been damaged
o The device exhibits a distinct change in performance, indicating a need for service
o The device does not operate normally when the operating instructions are followed
• Only adjust those controls that are covered in the operating instructions. Improper adjustment of other controls may result in damage that
will require extensive work by a qualified technician to repair.
• Do not connect the RJ-11 connector marked “UPGRADE” to a public telecommunication network.
• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life
support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this equipment in the presence of a
flammable anesthetic mixture with air, oxygen or nitrous oxide.
Rack Mounting Safety Instructions
• Before working on the rack, make sure that the stabilizers are secured to the rack, extended to the floor and that the full weight of the rack
rests on the floor. Install front and side stabilizers on a single rack or front stabilizers for joined multiple racks before working on the rack.
• Always load the rack from the bottom up and load the heaviest item in the rack first.
• Make sure that the rack is level and stable before extending a device from the rack.
• Use caution when pressing the device rail release latches and sliding a device into or out of a rack; the slide rails can pinch your fingers.
• After a device is inserted into the rack, carefully extend the rail into a locking position, then slide the device into the rack.
• Do not overload the AC supply branch circuit that provides power to the rack.
• The total rack load should not exceed 80 percent of the branch circuit rating.
• Make sure that all equipment used on the rack (including power strips and other electrical connectors) is properly grounded.
• Ensure that proper airflow is provided to devices in the rack.
• Ensure that the operating ambient temperature of the rack environment does not exceed the maximum ambient temperature specified for
the equipment by the manufacturer.
• Do not step on or stand on any device when servicing other devices in a rack.
5.2 Rack-Mounting Instructions for Console KVMs
The NetDirector Console KVM Switch is designed for mounting in a 1U rack system. For convenience, a rack-mounting kit is included with your
KVM for quick installation. The mounting options are explained in the sections that follow:
Note:
1. It is recommended that the unit be installed by two people; one to hold it in place and the other to attach it to the rack.
2. The rack-mounting kit that comes with the unit does not include screws or cage nuts. Contact your rack dealer for this hardware.
3. Allow at least 2 inches (5.1 cm) on each side for proper ventilation, and at least 5 inches (12.7 cm) at the rear of the unit for the power cord and cable kits.
1
1
2
2
