IB140058EN
For more information visit: www.eaton.com
Instructional Booklet
Effective: March 2016
Page
11
O&M Manual for 30-1000 Amperes
Manual Transfer Switch
Figure 12. Vertical Design Power Panel Mounting Reference in Inches (mm).
With the enclosed transfer switch equipment unpacked and ready
for mounting, proceed with the following steps:
Step 1:
The transfer switch enclosure door is hinge mounted with
removable hinge pins. To simplify the mounting procedure
and avoid damaging the door mounted logic panel, care-
fully remove the door and set aside in a safe place until
mounting is complete.
Step 2:
Install required mounting bolt anchors and the two upper
mounting bolts in the mounting surface.
Step 3:
Gently lift the enclosure and guide the elongated holes in
the upper mounting flange over the upper mounting
bolts, but do not completely tighten the bolts.
Step 4:
While still supporting the enclosure, install the two lower
mounting bolts in the lower mounting flange, but do not
completely tighten. Use shims, if required, to prevent
deformation of the enclosure when the mounting surface
is distorted.
Step 5:
Tighten all four mounting bolts after any required shim-
ming is completed.
Step 6:
Double check to ensure that all packing and shipping
material has been removed.
