Setting and Unsetting
Page 13
To quick set (if enabled):
1.
Press:
A
– To set the system fully (part-setting system) or to set partition 1.
B
– To set part set B (part-setting system) or to set partition 2.
C
– To set part set C (part-setting system) or to set partition 3.
D
– To set part set D (part-setting system) or to set partition 4.
2.
You will hear a continuous exit tone (unless the system is configured
for silent or instant setting). The system sets as described in step 6 on
page 11.
Unsetting the system
1.
Enter through the entry route designated by the installer (this is
usually the same as you used to leave the premises). Do not stray
from this route
– you may cause an alarm.
2.
Depending on how the system is configured, you may hear an entry
tone. If you hear the tone, go directly to the keypad, since you will
have limited time to unset the system before it generates an alarm.
3.
Enter your access code or present your proximity tag to the keypad. If
you enter your access code, the dis
play shows a “*” for each digit:
4.
If you are using a partitioned system:
a)
The bottom line shows the name of the first partition to which
you have access and its current state (U = unset, S = full set,
PB/C/D = part set B/C/D is set):
↕
b)
Press
or
to select the partition you want to unset.
c)
Press
or
to select the change you want:
↕
“U>PB/C/D” = change unset to part set B/C/D
“U>S” = change unset to full set
