5
EATON
IB528001EN
Installation instructions
Installation Instructions - Arena Series
Figure 2. Catwalk
●
●
Refer to the photometrics or project Installation Drawings to determine luminaire installation locations and luminaire
type.
●
●
Verify there are no obstructions in the designed luminaire locations and light paths. If beams, rigging, or any other
obstructions are present, shift the mounting location up to +/-2’ in either direction to install the fixtures in the closest
available location to provide a clear conical light path from the fixture to a 20’ diameter circle around the aiming point
that is completely free of obstructions.
●
●
All LED arrays in each fixture must have clear line of sight to aiming area. Do not install fixture partially obscured.
●
●
For each location, install a luminaire of the correct type. Unless otherwise noted, luminaires that share the same
model number are identical.
There are two standard mounting options for the luminaires:
1. Center Stud: For Ephesus catwalk mounting brackets
2. Multi-Mount: For threaded rods, pendants, eye nuts, or hooks
Select the appropriate mounting option for your project.
Catwalk Bracket (If applicable):
1. SET TOP RAIL BRACKET: Slide the top rail bracket over the uppermost rail in the catwalk structure.
a. Ensure the back set screw is secure to the railing. The set screw must make contact with the catwalk railing prior to
tightening the nut to prevent loosening. Tighten securely, but do not over tighten. Use of thread locking compound
is recommended.
2. BOTTOM RAIL BRACKET: Ensure bottom rail bracket slides over the lowest rail in the catwalk structure. If it needs to be
repositioned, remove the thru bolts and slide the bracket into the correct position, returning the thru bolts when the rail
mount is in the correct location.
a. Engage back set screw and tighten so that it is secure. The set screw must make contact with the catwalk
railing prior to tightening the nut to prevent loosening. Do not over-tighten. Use of thread locking compound is
recommended.
Mounting Option 1 - Center Stud Mounting:
●
●
If used with Catwalk Bracket, secure the bracket to the catwalk first.
●
●
Before installing fixtures, verify there are no obstructions in the designed luminaire locations and light paths. If beams,
rigging, or any other obstructions are present, shift the mounting b/-2’ in either direction to install the fixtures
in the closest available location to provide a clear conical light path from the fixture to a 20’ diameter circle around the
aiming point that is completely free of obstructions.
Safety Cable
Bottom Rail
Bracket
Set Screws
Top Rail Bracket
Hex Nut
Thru Bolt
Lock
Washer
