Eaton Endurant, Руководство по обслуживанию

Страница: 240 / 248

2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
237
TRSM0950 Appendix | Handling, Inspection and Cleaning of Parts
Handling, Inspection and Cleaning of Parts
Handling
All components of the transmission require a clean environ-
ment. If parts are not immediately reinstalled into the trans-
mission they should be stored in a clean container and
covered with a lint free cloth.
The components associated with the Mechatronic Trans-
mission Module (MTM) must be handled with care. These
components are crucial to the functionality of the transmis-
sion and should be handled in a clean environment.
Inspection and Cleaning
Inspect all transmission components with care. If any dam-
age is found during a component inspection, replace the
component and do not reuse.
NOTICE: Debris, foreign material, or moisture allowed to
enter into the vehicle air system or MTM air inlet port can
cause solenoids and air actuated components to malfunc-
tion.
If any component is exposed to dirt, or foreign material,
clean properly with a solvent based cleaner and dry with lint
free cloth before installing in the transmission.
Replacing Parts
When replacement is necessary, use only genuine Eaton
Transmission parts to assure continued performance and
extended life from your unit. Any replacement part that is to
be used to fix the transmission must first be cleaned with a
solvent based cleaner to remove debris and dried with a lint
free cloth before installation.