2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
199
TRSM0950
Installation
|
Rear Housing Installation
7.
Remove the 2 Rear Housing Alignment Pins
(RR1090TR).
8.
Install the remaining 21 Rear Housing 16 mm cap
screws and torque to 44.5 - 51.5 Nm (33-38 lb-ft) in a
criss-cross pattern.
9.
Lift transmission horizontally onto a bench.
WARNING:
Transmission weighs approximately 550
lbs. Keep fingers clear of pinch point between trans-
mission and other surfaces. Dropping transmission
may result in major vehicle component damage, severe
injury or death.
NOTICE:
Use an appropriate lifting device to safely lift
component.
10.
Perform “Output Yoke Installation” on page 141.
11.
Perform “Harness Bracket Installation” on page 203.
12.
Perform “Output Speed Sensor Installation” on
page 161.
13.
Perform “Mechatronic Transmission Module (MTM)
Installation” on page 151.
14.
Perform “Release Bearing and Clutch Release Yoke
Installation” on page 167.
15.
Perform “Transmission Control Module (TCM) Installa-
tion” on page 169.
16.
Perform “Transmission Installation” on page 211.
17.
Perform “Oil Fill Procedure” on page 213.
18.
Key on with engine running.
19.
Allow air pressure to build to governor cut-off.
20.
Connect ServiceRanger.
21.
Go To “Service Routines”.
22.
Select “Start” Clutch Calibration and follow on-screen
prompts.
23.
Select “Start” Rail Calibration and follow on-screen
prompts.
!
Содержание Endurant
Страница 1: ...Service Manual Endurant 12 Speed Automated Transmission TRSM0950 EN US March 2019 ...
Страница 2: ......
Страница 247: ......