Eaton EEV-7202, Руководство по обслуживанию, Страница: 56 / 63

56
m) Place synchronizer ring, low, on the synchronizer hub
locating it in the slots of the synchronizer hub. The annulus
rests on the six rollers. Place the synchro ring on sliding
sleeve. Hit on the synchro ring with both hands on either
side of the shaft and remove the support piece. Take out
the synchro ring and check all the six rollers are properly
seated.
n) Check that plungers and the springs are fully inside the
holes in the three central slots. Snap in by hand one roller
each into each of three central slots. Place synchronizer
ring, low, on the synchronizer hub locating it in the slots of
the synchronizer hub. Hold the synchro ring and shifter
sleeve with both the hands. Holding the sliding sleeve with
both hands; keeping the synchro ring pressed down with
thumbs of both hands, lift the annulus up with the fingers a
little. The three central rollers also seat in the grooves.
Ensure all the 9 rollers are properly seated.
Note: Alternatively all 9 rollers can also be assembled
following above step.
o) Support rear case on bench. Place spacer ring in the
recess.