14
EATON CORPORATION www.eaton.com
Instruction Leaflet IL 33-LGH-3
Effective September 2010
Digitrip Retrofit System for the ITE
LG-3000 (Frameless) Circuit Breaker
For Kits Supplied with an Auxiliary Switch Only.
H. Align the Microswitch with the holes in the Trip
Unit Mounting Bracket. Secure the Microswitch
to the Trip Unit Mounting Bracket, as shown,
using the (2) .138-32 x 1.00 screws, (4) flat
washers, (2) lock washers, and (2) nuts
supplied.
Step 9:
Installing the Trip Unit Assembly
A. While holding the Breaker Control Panel in
place, remove the two (2) copper bolts, washers
and nuts that secure the Control Panel
Assembly to the Breaker Control Panel
Assembly Mounting Bracket.
Note:
The original copper bolts and hardware
just removed can be used to mount
the Trip Unit Assembly and Breaker Control
Panel Assembly to the Control Panel
Mounting Bracket in the next Steps.
However, new mounting hardware is
supplied that can be used in place of the
original mounting hardware.
B. Align the holes in the Trip Unit Mounting
Bracket and the Breaker Control Panel
Assembly with the existing holes in the Control
Panel Mounting Bracket. Secure the Trip Unit
Assembly and the Breaker Control Panel
Assembly to the Mounting Bracket, as shown,
using either the original mounting hardware or
the (2) .250-20 x 1.00" bolts, (4) flat washers,
(2) lock washers, and (2) nuts supplied.
