Eaton Cutler-Hammer TRU-START, Руководство по эксплуатации и установке

Страница: 15 / 27

3.4 TERMINALS
3.4.1 CUSTOMER TERMINALS
TERMINAL NO. DESCRIPTION
J2 L1, N 115 VAC control voltage input, L1 being hot and N, neutral
L1 input is protected with internal fuse, 1A 250VAC
J4 1, 2 115 VAC supply for external interlock contacts
3 A normally open contact from the motor starter auxiliary must
be connected between this teminal and terminals 1 or 2 to sense
when the starter is de-energized to enable braking action
When using a TRU-START starter in conjuction with the DC
Injection, this terminal is to be jumpered to terminal 1 or 2
4 When 115VAC from terminals 1 or 2 is applied to this input,
braking is disabled
5 Common DCI relay contact
The Form-C relay is de-energized while braking and when a
fault exists
6 Normally open DCI relay auxiliary contact
7 Normally closed DCI relay auxiliary contact
R7 1, 2 Burden resistor terminals for calibration of DC injection current
See table in Section 4.4
3.4.2 TERMINALS FOR INTERNAL USE
TERMINAL NO. DESCRIPTION
J1 24V, COM This terminal is used by C-H as a 24V input to provide
battery back up for DC injection in case of power loss
J3 1, 2 CURRENT FBK
From current transformer for motor current feedback
J5 1, 2 MOTOR VFBK
From T1, T2 motor terminals for motor voltage feedback
SCR1 G1, K1 Gate connection to SCR 1
SCR2 G2, K2 Gate connection to SCR 2
SCR3 G3, K3 Gate connection to SCR 3
SCR4 G4, K4 Gate connection to SCR 4
OPT 1-20 Provided for ribbon cable link to TRU-START starter
This provides signals from the TRU-START to the DCI that
indicate the run status of the starter, replacing the auxiliary
input and prevents starting during DC injection or a fault
PAGE 11