Eaton Cutler-Hammer TRU-START, Руководство по эксплуатации и установке

Страница: 14 / 27

3.3 ADJUSTMENTS
3.3.1 POTENTIOMETERS
POT NAME RANGE DEFAULT
SETTING
DESCRIPTION
RV1 BRAKING
TIME
1-60 sec 30% Adjust the braking time
CW rotation increases the time
RV2 TORQUE 100-300% 50% Adjust DC current
CW increases the braking torque
(current)
3.3.2 LINK SELECTION
LINK NAME POSITION DESCRIPTION
JP1 VOLTAGE
LEVEL
LO
(Normal) Braking action starts when motor starter has opened
and the motor terminal voltage has decreased to 30%
of the line voltage.
HI Braking action starts when motor starter has opened
and the motor terminal voltage has decreased to 80%
of the line voltage. See important notes below.
HI setting is only used when the stopping time is critical and must be around 1-2 seconds.
For this application 300% DC current is not adequate. Consult factory before using this
jumper position.
When the DC Injection unit is set on the HI level a current surge could occur due to the
motor CEMF and the free wheeling action of the power circuit.
3.3.3 PUSHBUTTON
PUSHBUTTON NAME DESCRIPTION
SW1 RESET Reset IOC fault trip
PAGE 10