12. Remove the two screws holding the inverter board and remove the inverter board. This requires a
small Phillips-head screwdriver. See Figure 7.
Inverter
Board
Touchscreen
Power Connector
Touchscreen
Connector
Remove
Screws
Touchscreen
Jumper Cable
Loosen
Screws
Backlight
Connector
Touchscreen
Controller Card
Inverter Power
Connector
Figure 7
13. Unplug the backlight cable from the connector on the left side of the inverter board. See Figure 7.
The inverter power cable can be removed, if desired, but this is not required.
Note
: In newer models, a standoff had been placed next to the backlight connector to prevent the
cable from disconnecting from the inverter. The inverter has to be removed in order to
disconnect the backlight cable.
14. Unplug the touchscreen jumper cable from the touchscreen connector.
15. Remove the four screws in the corners that hold the front panel. See Figure 7.
January 2006
Page 6 of 14
01-50604-01
