January 2006
Page 14 of 14
01-50604-01
14. Insert the backlight cable through opening.
15. Reattach the display to the display plate. See Figure 19.
16. Reattach the display plate to the front panel making sure to feed the touchscreen cable through the
opening in the plate. (See Figure 18).
17. Reattach the backlight cable to the inverter board. Ensure that the two wires are on either side of the
small white standoff. See Figure 18.
18. Reattach the inverter board. See Figure 18.
19. Reconnect the inverter power cable to the inverter if it was removed. Make sure the cable is routed
through the cable clip. See Figure 18.
20. Reconnect the video cable, the inverter cable and the touchscreen cable to the CPU circuit board.
Caution
: If the display cable is not aligned correctly on the pins, the display and CPU can be
damaged beyond repair during power-up.
21. Reinstall the CPU circuit board. See Figure 16.
22. Reattach the power supply and reconnect the power connectors. Also reattach the fan bracket if the
unit is an Outdoor Series model. See Figure 15.
23. Reattach the standoffs in the four corners of the CPU circuit board. See Figure 14.
24. Verify that all previous connections are in place and that all wires are inside the edges of the display
plate. Reinstall the chassis cover. See Figure 13.
25. Connect the power source cable and any other cables.
Eaton Corporation
Operator Interface Business
811 Green Crest Drive
Westerville, Ohio 43081
tel: 614-882-3282
fax: 614-899-5390
