Instructional Booklet
Page
40
Effective: August 2007
O & M Manual for the CHGENLC Automatic
Transfer Switch with ATC-100 Control
For more information visit: www.eaton.com
IB00405002E
8.2 Optional SurgeTel
Figure 71. SurgeTel Installed on the TVSS.
Note:
The Eaton SurgeTel is designed to mount directly to the TVSS when
it is externally mounted to the ATS enclosure. If the TVSS was factory
installed inside the 100 A or 200 A SE ATS enclosure, the SurgeTel MUST
BE mounted outside the enclosure. See Section 7.4.1.12 for installation/
replacement information and the Instruction Bulletin supplied with the
SurgeTel for additional information.
Note:
If the SurgeTel will be mounted to the TVSS, no ground wire is
required between the SurgeTel and ATS. The TVSS ground will also
ground the SurgeTel.
Step 1:
Align the quick connector with the receptacle on the right
side, left side, or bottom of the TVSS. Slide the SurgeTel
into the receptacle until completely seated (see Figure
72).
Note:
The SurgeTel can also be mounted to other Eaton surge protection
devices that incorporate the quick connect feature.
Figure 72. SurgeTel Mounted to the TVSS.
Step 2:
Route the telephone service wire(s) to the
SurgeTel.
Step 3:
Remove the cover from the SurgeTel.
Step 4:
Connect the telephone service wires to the SurgeTel con-
nectors.
Note:
See the Instruction Bulletin supplied with the SurgeTel for complete
telephone wire connection information.
Step 5:
Check for a dial tone on a telephone connected to the
system.
Step 6:
Place an outgoing call and have someone call you back to
ensure that the system is working.
