7
EATON Char-Lynn
Delta Motors Parts and Repair Manual C-MOLO-TS003-E September 2007
Reassembly
Step 4
Place a bearing race, then a
thrust bearing, and then the
second bearing race into interior
bore of the housing. Place shaft
bullet No. 606256 over output
end of shaft and install into the
bearing housing.
Step 5
Install four dowel pins into the
blind holes on the balancing
ring using sufficient Loctite 277
to hold the pins. Install one
backup ring, then the o-ring
onto the balance ring. Install
the wave spring with sufficient
petroleum jelly to keep it in
place.
DeltaPartManual_v7.qxd:HydraulicsTech.qxd 9/19/07 11:40 AM Page 7
