Figure 25
*
Anti-Cavitation Valves
for Cylinder Ports
See page 4 for other
configurations
Ball 6,35 mm
[.250 in.] OD
Ball (2)
4,762 mm
[.1875 in.] OD
Roll Pin (1)
34,92 mm
[1.375 in.] L
Roll Pin (2)
40,00 mm
[1.575 in.] L
Manual Steering
Check Valve
O-ring
Figure 24
14
EATON Hydraulics
Series 10 VersaSteer Parts and Repair October 2004
17. Assemble drive and
spool/sleeve.
18. Insert pin through spool
and sleeve assembly
through hole in drive,
until pin is flush at both
sides of sleeve.
Pin
Figure 23
Assembly
19. Position spool and sleeve
assembly so that splined
end of spool enters 14
hole end of housing first
(figure 23).
Attention:
While inserting
spool and sleeve assembly
into housing, make sure parts
do not tilt out of position.
Push assembly gently into
place with slight rotating
action. Bring spool assembly
entirely within housing bore
until parts are flush at 14 hole
end of housing. With spool
assembly in this flush
position, check for free
rotation within housing by
turning assembly with
fingertip force at splined end.
20. Install 72,6 mm [2.86 in.]
ID O-ring in housing
(figure 25).
21. Install anti-cavitation
valves and manual
steering check valve (if
used) in holes, as shown
in figure 25. After
installing balls, inspect
holes to make sure they
are properly seated.
Note:
Check to insure that
spool and sleeve are flush or
slightly below 14 hole surface
of housing.
Attention:
Clean upper surface
of housing by wiping with palm
of clean hand. Clean each of
the flat surfaces of meter sec-
tion parts in a similar way just
before reassembly. Do not use
cloth or paper to clean surfaces.