Eaton Char-Lynn S Series, Информация по ремонту

Страница: 6 / 13

6
Figure 7
Bend Tip
Modify
Screwdriver
As Shown.
Remove all
Burrs.
Radius
on End
Radius
Pressure Seal
Exclusion Seal
Back-Up Ring
Mounting
Flange
Seal Removal Tool
Figure 8
Figure 9
Dust Seal
Back-up Ring (-009 and -010 Motors)
Mounting Flange
Pressure Seal
Oil
Seal
Figure 10
General Purpose Motors
S Series
Disassembly
15 The dust seal, pressure seal and oil seal will come off with the
flange. Use a seal remover tool, like the one shown in Fig. 7, to
remove the dust seal and pressure seal, as shown in Fig. 8 and 9.
Work nose of tool between pressure seal and flange. Pry seal partway.
Remove tool and repeat at a point 180
°
away. Push seal completely
out of cavity, see Fig. 8.
16 Remove output shaft from housing.
17 Remove bearing race and needle thrust bearing from shaft.
18 Some older housings have plugs. To remove the plug, use a 5mm
[3/16 inch] hex key, inserted through port opening, to push them out.