Eaton Char-Lynn S Series, Информация по ремонту

Страница: 3 / 13

3
General Purpose Motors
S Series
Geroler Motors
Tools required for disassembly and reassembly.
• Torque wrench (34Nm [300 lb-in] capacity)
• 300-400mm [12-16 inch] breaker bar
• 5/16–12 point socket no. 5422 (Heavy Duty— 56Nm [500 lb-in]
capacity)
• 5/16–12 point socket no. 5422 (Heavy Duty— 56Nm [500 lb-in]
capacity)
• Small screwdriver (150-200 x 6mm [6-8 x .25 inch] flat blade), see
page 6 for tooling information.
• 3/16 inch [5mm] hex key
• Shaft pressure seal installation tool for -008 motor P/N 600470
• Shaft pressure seal installation tool for -009 and -010 motors P/N
600523
• Seal sleeve or bullet P/N 600304 (1 inch dia. shaft), P/N 600466
The following tools are not necessary for disassembly and
reassembly but are extremely helpful.
• Small propane torch
*Tools available—by special order—through our service department.
Seal
Seal
Seal
Cap Screw
Housing
Drive
Spacer Plate
Geroler
End Cap
Drive Spacer
(Not Used on
-010 Motors)
Seal
Plug
(Not Used on -010 Motors)
Seal Washers
(Not Used with
6 Point (E10)
Drive Screws)
Cap
Screw
Exclusion
Seal
Mounting
Flange
Back-Up Ring
(-009 and -010
Motors)
Pressure
Seal
Seal
Bearing
Race
Needle
Thrust
Bearing
Output
Shaft
Key