Page 13
5-6kVA EU_EN
ENGLISH
2.6 Display functions
Press the Enter (
) button to activate the menu options. Use the two middle buttons ( and ) to scroll
through the menu structure. Press the Enter (
) button to select an option. Press the
button to cancel
or return to the previous menu.
Main menu
Submenu
Display information or Menu function
Measurements
[Load] W VA A pf / [Input/Bypass] V Hz /
[Output/Efficiency] V Hz % / [Battery] % min V n° /
[DCbus] V / [Average power usage] Wh /
[Cumulat. power usage] Wh since date
Control
Go to Bypass
Transfers the UPS on Bypass mode
Load segments On/Off
Commands the load segments
Start battery test
Starts a manual battery test
Reset fault state
Clears active fault
Restore factory set
Returns all settings to original values
Reset average power
Clears average power usage measurement
Reset cumul. power
Clears cumulated power usage measurement
Dry contacts test
Tests dry contact relay outputs
Settings
Local settings
Sets product general parameters
In/Out settings
Sets Output parameters
On/Off settings
Sets On/Off conditions
Battery settings
Sets battery configuration
Event log
Event filter
Selects faults, alarms and/or events to display
Event list
Displays the events stored
Reset event list
Clears events
Fault log
Fault list
Displays the faults stored
Reset fault list
Clears faults
Identification
[Product type/model] / [Part/Serial number] / [UPS/NMC
firmware] / [Com card IPv4], [Com card IPv6], [Com card MAC] /
[Detected accessories]
Register product
Links to Eaton registration website
2.7 User settings
The following table displays the options that can be changed by the user.
Submenu
Available settings
Default settings
Local settings
Language
[English] [Français] [Deutsch] [Español]
[
Русский
] [Português] [Italiano]
Menus, status, notices and alarms,
UPS fault, Event Log data and
settings are in all supported
languages.
[English]
User selectable when UPS is
powered for the first time.
Date/ time
Format:
[International] [US]
[International]
LCD
Modify LCD screen brightness and
contrast to be adapted to room light
conditions.
Audible alarm
[Enabled] [Disabled on battery] [Always
disabled]
Enable or disable the buzzer
if an alarm occurs.
[Enabled]
In/Out settings
Output voltage
[200V] [208V] [220V] [230V] [240V]
Can be changed only in Standby mode
[230V]
Output frequency
Frequency converter:
[Enabled] [Disabled]
Frequency settable in frequency
converter mode
Disabled
Load segments
[Auto start delay]
[Auto shutdown delay]
Group1: [3s] Group2: [6s]
Group1: [Disabled]
Group2: [Disabled]
Output mode
[Industrial] [Network]
Set UPS behavior regarding transfer
on Bypass
[Industrial]
Input volt hysteresis Sets input voltage hysteresis
from 1 to 10V
[10V]
High Efficiency
mode
[Enabled] [Disabled]
Power the output from Bypass
for high efficiency
[Disabled]
Bypass transfer
[Transfer if BP AC NOK]
[Enabled] [Disabled]
Allow transfer on Bypass out
of tolerance
[Enabled]
2. Presentation
