PE管
PAGE -11 -
PAGE - 10 -
2.4 Connection
2.4.1 Quick connecting pipe: The machine totally adopt quick connecting fitting.
All you have to do is to insert the PE pipe and connect with quick fitting, but
it should be inserted to the bottom of connector in order to prevent leakage.
(As shown in Figure 15)
2.4.2 Cutting a piece of 1.8~2PE pipe and connect to water inlet adaptor.
Then, go through hole2 and connect to the water inlet of machine
(As shown
in Figure 17-No. 1). Please make sure the pipe is in the bottom.
2.4.3 Cutting a piece of 60cm~80cm PE pipe and connect to the
untreated water outlet of machine
(As shown in Figure 17-No.2). Another
side connect to untreated water.
2.4.4 Cutting a piece of 80cm~100cm PE pipe and connect to the
high pressure switch. And the other side is connected to the ball valve of
storage tank.
2.4.5 Cutting a piece of100cm PE pipe and connect to the post in line cartridge
and the other side is connected to inlet of faucet.
★
Please make sure all of above
mentioned are OK, and then
manage the PE pipes, then put
it back to counter.
★
Any problem, please call for
service.
PE pipe
quick connector
Figure 16. Quick connecting
pipe (sketch diagram)
★
Note: When replace filter cartridge or move the
position of this machine, if there is PE pipe
disconnect and re-connect action, the end
of the PE pipe may be damaged. If there is
leakage at the connection between the pipe
and the connector, please cut off a small
piece at the end of the pipe and connect the
quick connector again.
FIGURE 17. CONNECTION DRAWING
CONNECT TO WATER INLET.
CONNECT TO FAUCET
AND OTHETR SIDE TO
IN LINE CARTRIDGE.
CONNECT TO HIGH
PRESSURE SWITCH
OTHER SIDE TO BALL
VALVE.
OUTLET FOR
UNTREATED WATER
PIPE
SINK
HOLE 1
HOLE 2
