深圳市普伦特科技有限公司
www.easythreed.com
7 / 10
2.4,Load Filament and Unload Filament
(1).
click home page“preheat”
，
come to preheat page
，
and click the "+" to increase the target
temperature value on the right side of the diagonal bar to about 200 degrees (the thermometer
icon below can change the value added with each click), The nozzle starts to heat up. When the
left side value rises to the temperature value set on the right, click "Back"
(2).
Click the "Extrude" to enter the feeding and retract interface. The value E1 in the middle is
the length of the feeding. Each time you click the "In", the length of the feeding will increase
(click the icon of the left and right arrow below to change the size of the value change). When
the nozzle spits out the filament and spits out the set length, the feeding is completed
(3).
If you want to change filament or take out filament from the printer, Click "extrude" to
enter the operation interface of Feeding and Retract, click "Out" to increase the length of
retract filament, until the filament come out from the printer head, the retract is completed,
and click "Back" to return.
.
(Note
：
feeding or retract need to be“preheat”, set the required target
temperature. Different materials may require different temperatures. PLA
material is 200 degrees, after the nozzle is heated to the set value ,then
feeding or retract)
