深圳市普伦特科技有限公司
www.easythreed.com
10 / 10
5,Accessories List
d
irectory
1 filament
2 USB cable
3 power cord
4
、
Oblique tongs
quantity
1
1
1
1
Picture
Directory
5 shovel
6 Wrench
7 Card reader
8 TF card
quantity
1
1
1
1
Picture
6,FAQ
6.1.
Why is the printing model not adhesive to the printing bed?
（
1
）
The nozzle is too far away from the bed, Adjust the distance between the nozzle and the platform, to
assure that the distance is just a sheet of paper
。
（
2
）
Hotbed temperature is too high or too low. The temperature of ABS printing hotbed should be
about 110
℃
, and that of PLA printing hotbed should be about 50
℃
.
6.2.
Why the filament do not come out from the nozzle?
（
1
）
Check the feeding : check the feeding motor is working normal or not.
（
2
）
Check the temperature of the sliced file
：
PLA Filament temperature 180
℃
-220
℃
, temperature too low may cause this problem
。
（
3
）
Check whether the nozzle is blocked
：
When the temperature of the nozzle is heated(PLA is heated to 210
℃
)and then do feed, pushed
slightly by hand to see if the nozzle is out of filament silk . If the nozzle is out of silk, there is no block
in the nozzle. If no silk come out, remove the nozzle to clean up inside the nozzle or replace the
nozzle.
（
4
）
Is the platform too close to the nozzle?
If the platform is too close to the nozzle, there is no space for filament silk come out, you
need adjust the distance between the nozzle and platform, the distance should be right the
thickness of a sheet of paper.
