深圳市普伦特科技有限公司
www.easythreed.com
6 / 10
2.3
，
Install Filament
：
(1) Use scissors to cut off the end of wire about 2-5mm, so that the filament front is
smooth and straight.
(2) Straighten the length of the end of the filament about 10-15 mm with a hand.
(3) Insert the filament into the slot of the thread insertion at the back of the rocker
arm of the extruder.
(4) Press the rocker arm of the extruder to make the filament pass through the inlet
gear and the conductor groove into the Teflon guide pipe.
(5) Push the filament into the pipe as close as possible to the end of the print head,
and then release the rocker arm.
Teflon pipe
Extruder gear
rocker arm
