Thank you for purchasing NANO plus 3d Printer,NANO plus is kind of consumer 3d printer,it can
make your custom creations come to life, Just plug in the printer, download the models, click print,
and watch as you bring an object into the world through 3D printing
For updated information, please visit
www.easythreed.com
1.0 Un-Boxing NANO plus 3d printer
1.
Lift the NANO plus from it packaging box. Remove bubble wrap, foam. Tape.
2.
Inside is an NANO plus 3d printer and accessories box with manual, filament, power adaptor,
TF card, card reader, screw driver. Filament holder
3.
Be sure to remore the “clips” in the left and front right corners of the printer. The clips are only
for protection during transportation (As shown in the above figure 1)
4, install the filament holder at the left side or right side of the printer, right is best side.
(Don’t put on front side and back side. These two side will be not good for printing quality.) pls
see the below picture show. And hang on the filament.
