Easystreet Air Commander, Руководство пользователя

Страница: 3 / 10

3
Technical Support
1-800-248-0892
Ext. 2
NOTE: This compressor will mount on the right
(passenger) side of the engine. It may be necessary to
relocate or remove the air conditioning lines. If the oil is
low in the compressor, use Polyol Ester (P.O.E.) P.A.G. oil
and fill to specified amount.
I. Assembling the Compressor
1. Attach the clutch to the compressor using the four bolts that
come in the box with the clutch (Figure 2). Tighten the bolts
securely. NOTE: Make sure that the wire is at the bottom right
hand side of the compressor.
2. Place the pulley (E) over the clutch and align the keyway. Attach
the pulley (E) using the provided hardware. Tighten securely to
the shaft (Figure 4).
3. Attach the small clamp that came with the clutch using bolt (FF)
and flat washer (GG). Route the wire through the clamp (Figure
3).
4. Attach the plate (L) to the left side of the compressor (engine
side) using bolts (II), lock washers (JJ), and flat washers (GG).
Be sure to insert the carriage bolt (HH) before bolting the plate
down (Figure 5). NOTE: The long tab at the bottom of the
bracket faces the rear of the compressor (Figure 5).
5. Remove the small bolt on the open side of the compressor above
the line clamp previously installed and check the oil level in the
compressor with the supplied dipstick (AH). The oil level should
be from 1” to 1
1
/
4
" on the dipstick. The compressor should have
a total of 8 fl. oz. (237 ml). Use Polyol Ester (P.O.E.) P.A.G. oil
only. Attach the plug and tighten.
Figure 2
Figure 3
Figure 4
Figure 5