2
5.
Always connect to a Ground Fault Circuit (GFCI) to prevent electrical shock. Never
submerge connecting power cable plug in water.
6.
Never let the pump run without water as this will damage the impeller,
overheat and possibly burn out the pump. This pump must stay
submerged entirely when operating. Running pump low on water will
cause overheating, premature failure and will void warranty.
7.
Do not use this product in bathrooms or swimming pools. For use with fresh water only.
8.
Do not use in water over 95° F (35°C).
9.
All electrical work must be performed by a qualified technician. Always follow the
National Electrical Code (NEC) or the Canadian Electrical Code as well as all local,
state and provincial codes. Code questions should be directed to your local electrical
inspector. Failure to follow electrical codes and OSHA safety standards may result
in personal injury or equipment damage. Failure to follow manufacturer’s installation
instructions may result in electrical shock, fire hazard, personal injury or death, damaged
equipment, provide unsatisfactory performance and may void manufacturer’s warranty.
10. Do not carry or lift the pump by the power cord.
11. Never use an extension cord or tamper with power cord. Power cord should not
become bent, twisted, abraded or cut. A damaged cable may cause electric
leakage, shock or fire. The power cord cannot be replaced, and unit should be
replaced if cord becomes damaged.
12. Do not remove the pump housing during
operation of the pump.
Assembly and General Installation
1.
Slide the fountain float down over the top of
the pump until it sits securely.
2.
Secure the float by inserting the three thumb
bolts into every other hole. Finger tighten the
bolts until the tops of the bolts are flush with
the inner rim of the float. Do not overtighten.
3.
Connect the light's power cord to the
transformer.
4.
Connect the mooring/anchor ropes to the float.
5.
Place the fountain in your pond and secure
with the mooring/anchor rope.
6.
Plug the pump and light cords into a
GFCI outlet. (See Safety and Electrical
Connections on page 1 for important
instructions about power connections.)
7.
Set the timer for the lights if desired.
Thumb Bolts
Inner Rim
of Float
Step 2
Step 3
Step 1
