9
Loading Media Rolls
1.
Remove the Media mandrel, load the media onto the system, lock into place and ensure it is centralized. If
the media is the same size as the laminate, please ensure these are
2.
Tensioning the rolls:
Media Mandrel - Depending on how straight
and tight the media has been put onto the
core it can require different amounts of
tension. Usually, it only requires a couple of
turns.
Take up unit
–
To ensure the media laminated
is collected well it requires a firm tension.
Do not overtighten into the machine cover.
3.
Raise the laminating roller using the Roller Up/Down Switch and pull down the feed table. Feed the media
from the mandrel directly to the bottom laminating roller and through the rollers as shown above. Please
ensure you have not threaded it under the stand beam it must go directly from the roll to the lower
laminating roller.
1.
Remove the media mandrel, load the media onto the system, lock into place and ensure it is centralized.
If the media is the same size as the laminate please align the media and laminate together.
3. Raise the laminating roller and pull down the feed table. Feed the media from the mandrel directly to the
bottom laminating roller and through the centre of the top and bottom roller.
Please ensure you have not threaded it under the stand beam as this can cause creasing.
