TSRP POWER CONNECTION KIT
Installation Instructions
3
the outside
of each bus
wire.
12. Starting at
the end, pull
each bus
wire away
from the
core mate-
rial.
13. Remove exposed core material.
14. Cut .25" (6mm)
off the end
of each bus
wire.
CABLE STRIPPING PROCEDURE
For cables without overjacket (braid only), proceed
directly to step 4.
1. Lightly cut around
heater overjacket 5"
(127mm) from the end.
Bend cable to break
overjacket.
2. Lightly cut overjacket
up the center between
first cut mark and the cable
end. Bend cable to break the
overjacket.
3. Remove overjacket from
the heater cable.
4. Move braid back toward the
overjacket, creating a bulge.
(For cables without overjacket, ap-
ply a ring of electrical tape 5" from end
of cable, then
move braid
back toward
tape, creating a
bulge.)
8. With braid prepared as shown, lightly cut
around heater jacket 4" (102mm) from the end.
Bend cable to break outer jacket.
9. Lightly cut the
outer jacket up the
center between the
first cut mark and
the
cable end. Bend cable
to break outer jacket.
10. Remove the jacket from
the heater cable.
11. Shave the core material from
a
WARNING!
Do not cut or nick braid.
5. At the bulge, separate the braid to make an
opening.
6. While bending the
heater cable, work it
through the braid opening.
7. Pull the braid tight
.
4.5" (114mm)
4"
(102mm)
a
WARNING!
Do not cut or nick wires.
(continued on next page)