1.Never operate the system in an enclosed or partially enclosed area without ventilation (like a garage).
Once the product is properly installed, this system can remote start the vehicle by a command signal
from the remote control. Therefore, never operate the system in an area that does not have adequate
ventilation. The following precautions are the sole responsibility of the user; however, authorized
EASYGUARD Electronics dealers should make the following recommendations to all users of this
system:
3.It is the user's sole responsibility to properly handle and keep out of reach from children all remote
controls and other accessories in the kit to assure that the system does not remote start the vehicle
occasionally.
Use of this product in a manner contrary to its intended mode of operation may result in property
damage, personal injury, or death. Except when performing the safety checking indicated in this
installation guide:
(2) Never remote start the vehicle with the keys in the ignition. If the vehicle starts in gear, cease remote
start operation immediately and consult with the user or the alarm installer to fix the problem immediately.
Zhongshan
EASYGUARD Electronics Co.,ltd WILL NOT BE HELD RESPONSIBLE OR PAY FOR ANY
INSTALLATION OR REINSTALLATION COST.
USER MUST INSTALL A CARBON MONOXIDE DETECTOR IN OR ABOUT THE LIVING AREA
ADJACENT TO THE VEHICLE. ALL DOORS LEADING FROM ADJACENT LIVING AREAS TO THE
ENCLOSED OR PARTIALLY ENCLOSED VEHICLE STORAGE AREA MUST REMAIN CLOSED AT ALL
THE TIMES.
2.When parking in an enclosed or partially enclosed area or when having the vehicle serviced, stop using
the remote start function.
(1) Never remote start the vehicle with the vehicle in gear, and
(3). When use remote engine start function, the gear selector should be in Neutral(N) Or Parking(P)
position.
Remote start function for manual transmission pose significant risks if not properly installed and operated.
When testing to ensure the installation is working properly, only remote start the vehicle in neutral gear,
on a flat surface and with a functional, fully engaged parking brake. Do not allow anyone to stand in front
of or behind the vehicle.
Before Starting the Installation
Please read all the installation guide before starting the installation. The installation of this item requires
interfacing with many of the vehicle’s systems. Many new vehicles use low voltage or multiplexed systems
that can be damaged by low resistance testing devices, such as test lights and logic probes (computer safe
test lights). Test all circuits with a high quality digital multi-meter before making connections.
Installation Guide
Some things to remember about where to mount the control module:
Deciding on Control Module Locations
Never put the control module in the engine compartment!
When mounting the control module, try to find a secure location that will not require you to extend the
harnesses’ wires. Keep it away from the heater core (or any other heat sources) and any obvious leaks.
Some good control module locations are: Above the glove box, inside the center console, above the
under-dash fuse box, or above the radio.
The first step in hot-wiring a vehicle is removing the driver's side under-dash panel to access the starter
and ignition wires. If the control module is placed just behind the driver's side dash it can easily be
disconnected.
In order to have a maximize PKE induction range, the following antenna mounting options should be
discussed with the customer to better suit need.
Do not disconnect the battery if the vehicle has an anti-theft coded radio. If equipped with an air bag,
avoid disconnecting the battery if possible. Many airbag systems will display a diagnostic code through
their warning lights after they lose power. Disconnecting the battery requires this code to be erased,
which can require a trip to the car dealer.
To avoid accidental battery drainage, turn off the interior lights or remove the dome light fuse.
-04-
©
EASYGUARD
Electronics
.
All
right reserved.
-03-
©
EASYGUARD
Electronics
.
All
right reserved.
2.Mount the alarm antenna to the upper inside of the front windshield (see photo for example)
1.Assembly the alarm antenna (If equip with external antenna)
3.Fix the antenna with sticker and the plastic cap
4. Try your best to keep the antenna away from any metal product to avoid interference.
