If there is chip immobilizer in original key fobs, please follow below method
2.Put the car original remote control(include the chip immobilizer) into the coil, make sure the induction
of the chip immobilizer and the coil is good.
Method 1:
1.Take out the original induction coil from the ignition lock.
1.Take out the chip immobilizer from the car OEM remote control.
Method 2:
2.Take out the original induction coil from the ignition lock.
Installation for chip immobilizer
Reminder:
Some chips with weak signal are hard to start the car when put on the car original coil.
Then need to add a coin or other metal pad underneath the chip to enlarge the signal of it (see above
drawing)
Car original
induction coil
3.Stick the chip immobilizer on the induction of car coil, make sure the induction of chip and coil is good.
Chip
Foam or other materials
Induction coil of original car
Coin or other metal pad
Car original
induction coil
Starting current: 30A
Frequency: 433.92Mhz
ON current: 30A
Technical Parameter:
Static current: <10mA
Working Voltage: DC12V±2V
ACC current: 30A
Method 3:
Use an extra bypass module to bypass it, installation steps as below:
1. Put the whole remote control( please take out the battery from remote first) include the chip immobilizer
into the bypass module.
Note:
if size of remote control is big, user can put PCB or chip inside the bypass module.
2.Taping induction wires 2-3 circles on the ignition lock header
Important:
Please fix the car OEM remote control and induction wire well
around the ignition lock header to make sure that the car can be started.
Bypass module
Car OEM remote
control must fix well
in induction coil
Induction wire taping on the ignition lock
Fix the induction
wire well on the ignition
lock with electrical tape
Induction coil
-24-
©
EASYGUARD
Electronics
.
All
right reserved.
-23-
©
EASYGUARD
Electronics
.
All
right reserved.
