AFTER SALES SUPPORT
USA
First use
17
USA
866-235-5029
1. If necessary, remove the attached support feet
7
if you intend to mount
the convection heater on the wall.
2. Measure the distance between the two vertical slots in the rear panel of the
convection heater (see
fig. D
).
3. Mark this distance on the wall you would like to operate the convection
heater on.
Be absolutely sure to observe the specifications regarding safe distances at
the beginning of this chapter.
4. Drill two holes with a diameter of 0.31 in (8 mm) and a depth of
1.38 in (35 mm) in the wall and insert a dowel
6
in each of them.
5. Screw the brackets
2
and
3
in place so that they are mirror-inverted
with respect to one another.
Keep in mind that the brackets open outwards, that is, the mounting hole
points out and to the side.
6. Screw the two other brackets onto the bottom of the housing.
For this, insert the long side of the bracket on the back of the housing into
the slot on the bottom of the housing. Make sure that the mounting hole
points down in the process towards the ground.
7. Use a short screw
5
to screw each of the mounting brackets onto the
housing.
8. Hang the convection heater on the two brackets that are mounted on the
wall.
Make sure that the two slots in the rear panel of the convection heater hous-
ing slide into the opening on the two mounting brackets and that the con-
vection heater is hung so that it is straight.
There must be at least 1.9 ft (50 cm) of space between the bottom edge of
the housing and the ground.
9. On the wall, mark the center points for the mounting holes that will carry
the two mounting brackets on the bottom of the housing.
Take the convection heater down again and drill the two holes where the
marks are.
10. Insert one dowel in each of the holes you drilled.
11. Hang the convection heater back on the support brackets on the back of the
housing.
12. Screw the bottom brackets onto the wall with two long screws
4
.
You have successfully mounted the convection heater on the wall.
Korrektur_V6
hat is, the m
at is, the m
tom of the housing
m of the h
ket on the back of
g. Make sure that t
ake sure that
ds the ground.
e ground.
w each of the mou
ach of the m
eater on the two b
er on the tw
e two slots in the r
wo slots in th
he opening on the
pening o
ter is hung so that
ter is hung so
ust be at least 1.9 ft
be at least
sing and the gro
sing and the
l, mark th
l, ma
nting
Содержание CH-Y01AFT
