customerservice
@biddefordblankets.com
ITEM: 6411
AFTER SALES SUPPORT
USA
800 789 6441
Turning “OFF”
Turn the controller OFF manually by pressing the ON/OFF button. When the
controller is OFF but plugged in, you will see a red or green light on the controller
without the number displayed. Seeing this light alone means the controller is in
standby mode and the bedding is off and not heating
.
Turn OFF or unplug the
controller when not in use.
Pre-Heat (Specific Models Only)
Press the PRE-HEAT button. This will start pre-heating the bedding and “p” will be
displayed on the controller. The heat setting will change to the last setting after 1.5
hours. If you want to change to another setting during the pre-heat period, press the up
or down button.
Washing Instructions - WARNING: Failure to follow these washing
instructions may damage the product and make it unsafe.
Wash by hand or as follows in automatic washer using slow agitation and
normal spin speed:
1. Fill washer with warm water.
2. Add minimum amount of all-purpose detergent, agitate to dissolve.
3. Add bedding and soak for five minutes.
4. Agitate for two minutes.
5. Spin.
6. Fill for cool rinse.
7. Agitate one minute.
8. Spin.
9. Dry in an automatic dryer on low heat, five minutes only, or line dry.
10. Remove bedding from dryer and drape over parallel lines or a shower rail
to finish drying.
CAUTION!
– Do not iron your bedding.
CAUTION!
– Do not dry-clean this product. Cleaning solvents may have a
deteriorating effect on the insulation of the heating element.
CAUTION!
– Do not use a wringer. You may hand wash this product.
CAUTION
! – Do not dry in a commercial dryer such as those used in
Laundromats.
CAUTION!
– Do not power-up this product while it is still damp. For
safety’s sake, wait until the product is completely dry before connecting it
and plugging it in.
CAUTION!
– Do not use pins – they may damage the electrical wiring.
7
