customerservice
@biddefordblankets.com
ITEM: 6411
AFTER SALES SUPPORT
USA
800 789 6441
Getting Started 4
1. Remove the product from the package along with the controller(s).
2. Lay the blanket out flat on the bed, with the connectors placed at
the foot of the bed. The label should always be facing UP toward the ceiling,
at the foot of the bed.
3. Securely attach the connector cord from the controller to the connector on the
product.
Make sure that the connection is firmly secured
. If you have a
Queen or King sized product it is not necessary to connect both sides for the
product to operate properly; however you will only receive heat to the side of
the product that is properly connected. NOTE: It does not matter which
controller is attached to which side of the product, the controllers are
interchangeable.
CAUTION!
– Do not route electrical cords between the mattress and
box spring. Do not allow the cords to be pinched, trapped, or crossed.
See Safety Instructions.
CAUTION!
– Do not tuck in the wired area of this bedding.
See Safety
Instructions.
CAUTION!
– Do not cover the controller.
See Safety Instructions.
4. Insert power cord into standard 120volt wall outlet.
Blanket
Step 1-
Remove the
product from
the package
along with the
controller(s)
Step 2 - Lay the
blanket out flat
on the bed,
with the
connectors
placed at the
foot of the bed.
The
label
should
always
be facing UP
toward the
ceiling.
CAUTION! – Do not tuck in
the wired area of this
bedding
Step 3 - Securely attach the connector cord from the
controller to the connector on the product. Make sure
that the connection is firmly secured
Label
Controller
Connector
Cord
Step 4 – Insert power
cord into standard
120volt wall outlet
Controller
Power Cord