EASYair EME5 Series, Инструкция по установке, использованию и техническому обслуживанию

Страница: 32 / 52

32
5. ALARMS DESCRIPTION
If a serious fault occurs, it is very important to switch the oven off at
the omnipolar
switch and close the water and gas shut-off valves upstream of the
oven�
PROBLEM SOLUTION
The oven doesn't start�
Check that the omnipolar circuit breaker is closed and the mains
electricity is present�
Check that the gas shut-off valve upstream
of the oven is open�
Check the integrity of the protection fuses of the oven�
Make sure the oven door is properly closed�
Make sure you have set the parameters of the cooking cycle
properly�
Make sure the oven is not in failure�
If the furnace does not start after all these operations, contact the support centre�
The fans stops during
operation�
Turn off the oven and wait for the thermal breaker of the motor
to be restored automatically�
Make sure the cooling vents are not obstructed�
If the problem persists, contact the support centre�
Internal lighting
is not working
Use heat-resistant lamps�
Replace the lamps proceeding as follows:
• Make sure that the omnipolar circuit breaker installed
upstream of the oven is open and the appliance is cold�
• Unscrew the bulb protections inside the chamber�
• Remove the seal�
• Replace the bulb�
If the problem persists, contact the support centre�
Water is not delivered
from humidifier pipes
Check that the water shut-off valve is open�
If the problem persists, contact the support centre
�