Easy Caravanning TakeOff Active, Руководство пользователя

Страница: 12 / 36

ARRIVING AT YOUR DESTINATION
10
User manual TakeOff
• Steadily pull the roof down with two
hands, using the grips (11) at the back, on
the inside of the roof.
• While doing this, check whether the
flex-wall canvas properly drapes inwards
and remains clear from the lifting me-
chanism during all the phases of closing
and also doesn’t get entrapped between
the trailer and the roof. Be very cautious in
trying to prevent damage to the canvas.
PLEASE NOTE:
damages to the canvas,
due to closing the roof carelessly and not
strictly observing the previously de-
scribed procedure, are not covered by
the warranty.
Should 1 of the 2 sides close faster than
the other during closing, causing the roof
to show an inclination in transverse direc-
tion, then immediately stop the closing
process and start again. Closing the roof
unevenly on the left and right hand side
may cause lasting damage to the lifting
mechanism.
• Make sure that the roof locking knobs at
the front, on the left and right, remain in
extended (UNLOCK) position.
• First push the back of the roof into both
locking devices and check the correct
closure.
• Now push the roof at the front of the
trailer down, on the left and right hand
side and turn the control knobs for about
90 degrees to let the roof locking. Check
the correct locking by attempting to pull
the roof up.
• Close the steps and lock them by use of
the key.
Power supply
Under the floor, on the right hand side, a 230 V
socket is installed for the power supply of the
TakeOff. In some versions, this 230 V socket can
be found in the back wall of the trailer. First ins-
ert the CEE plug into the TakeOff, always roll out
the cable entirely and then insert the plug into
the camp site’s power supply point. Frequently
check the functioning of the earth-leak switches
by use of the test button. The earth leak circuit
can be found in the cabinet at the back right.
Always ensure that the 13-pole plug of the
TakeOff has been disconnected before con-
necting to 230 V. The converter is equipped
with a fuse (safety).
Gas installation
The following gas cylinders can be placed in
the gas bottle compartment:
• Benegas 5 kg light-weight
• Steel cylinder 2.5 kg