4 SPRING LOADED “J” LOCKS
LOCK OPERATION
For safety, follow these ‘J’ Lock instructions:
The OX Telescopic Multi-Ladder outer sections allow
the ladder to telescope and change heights in all the
configurations, besides the scaffold mode. Each of these
configurations is made possible using the 4 Spring Loaded
“J” locks 2 each on either side.
The Spring Loaded “J” locks are operated by pulling straight
out and then rotating them away from the holes in the rails.
Each “J” lock works independently allowing the end user to
work the lock with one hand while holding the ladder with
the other.
To adjust the height of the ladder:
1) Unlock the 4 “J” locks by pulling out and rotating the “J”
lock away from the rung hole (See Figure 3).
2) Raise the inner section to the desire height.
3) While holding the inner ladder section with one hand,
lock the 4 “J” locks by rotating them into the locked
position (See Figure 4).
CAUTION
- Ensure all ‘J’ locks are secure in a rung hole before climbing.
- Maintain control of the inner section while raising or lowering,
failure to do so could result in injury.
7
