NOTES OR PREVENTIVE MEASURES
1
、
Environment
1
）
The machine can be performed in environment where conditions are dry with a
dampness lever of max 90%.
2
）
Ambient temperature is between -10 to 40 degrees centigrade.
3
）
Avoid welding in sunshine or drippings condition.
4
）
Do not use the machine in environment where condition is polluted with conductive
dust in the air or corrosiveness gas on the air.
5
）
Avoid gas welding in the environment of strong airflow.
2
、
Safety norms
The cutting machine has been installed protection circuit of over voltage and over
current and over heat. When voltage and output current and temperature of machine are
exceeding the rate standard, welding machine will stop working automatically. Because
that will be damage to welding machine, user must pay attention to the following notice.
1
）
The working area is adequately ventilated
！
The cutting machine is powerful machine, when it is being operated, it is generated by
high currents, and natural wind will not satisfy machine cool demands. So there is a fan
in inter-machine to cool down machine. Make sure the intake is not in block or covered,
it is 0.3 meter from welding machine to objects of environment. User should make sure
the working area is adequately ventilated. It is important for the performance and the
longevity of the machine.
2
）
Do not over load
！
The operator should remember to watch the max duty current (Response to the selected
duty cycle).
Keep welding current is not exceed max duty cycle current.
Over-load current will damage and burn up machine.
3
）
No over voltage
！
Power voltage can be found in diagram of main technical data. Automatic compensation
circuit of voltage will assure that welding current kept in allowable arrangement. If
power voltage is exceeding allowance arrangement limited, it will damage the
components of machine. The operator should understand the situation and take
preventive measures.
4
）
There is a grounding screw behind welding machine, with grounding marker on it
Mantle must be grounded reliable with cable which section is over 6 square millimeter
in order to prevent from static electricity and leaking.
5
）
If welding time is exceeded duty cycle limited, welding machine will stop working
for protection. If the machine is overheated, temperature control switch is on “ON’’
position and the indicator light is red. In this situation, you don’t have to pull the plug,
in order to let the fan cool the machine. When the indicator light is off, and the
temperature goes down to the standard range, so it can weld again.
Содержание VERSA CUT60
Страница 1: ...USER S MANUAL MODEL...
