To order parts and supplies: 800.343.9353 >> eastwood.com
5
SET-UP
• Place the Arbor Wrench over the flats of the Arbor Shaft to keep it from rotating.
• Thread the Backing Pad onto the Arbor Shaft Post.
• Using a good quality Teflon sealing tape (not included), thread the 1/4” MNPT, Male quick
disconnect inlet fitting into the air inlet.
FIG. 1
CONNECTION
• Be sure that the air supply to the tool is clean and dry. Moisture in the supply line will quickly
damage the motor and valves.
• A minimum 3/8” I.D. air line should be used for optimal performance.
OPERATION
• Twist the Cleaning Disc post firmly into the Backing Pad receptacle until it seats fully.
• Connect air supply, depress Paddle to begin rotating action. Speed is regulated by pressure
applied to the Paddle.
MAINTENANCE
• Add several drops of air tool oil before each use by dropping directly into the air inlet.
• If tool is to be unused for an extended period, add 10 drops of air tool oil directly to the air
inlet, rotate the tool motor by hand several times to distribute the oil throughout the motor
and gearbox then store the tool, handle up.
Arbor Wrench
Flats
Thread-On to Arbor Shaft Post
Twist-On Cleaning Disc
✓
✓
✓
