To order parts and supplies: 800.343.9353 >> eastwood.com
9
OPERATION
• Adjust the Stop Fence to the desired angle of the cut. Always verify with a square for 90° or
protractor for other angles.
• Using the Material Clamp, secure the workpiece and, if necessary, adjust the angle of the cut.
• Raise the Saw by pushing down on it
and pulling out the Locking Pin located
at the lower left side of the motor
mount, just below the pivot
(FIGS 9 & 10)
.
• Plug the Power Cord into the nearest
120 V~, grounded, 20 Amp electrical
outlet. Be sure the power cord is away
from and out from under the Chop Saw
blade. Push in the Trigger Safety Lock
Button
(FIG 11)
on the underside of
the handle and pull on the Trigger
(FIG 11)
to run the Saw motor.
Allow the Blade to reach full
operating speed.
• With one hand on the Handle and the
other hand kept away from the Saw,
slowly lower the Saw down onto the
Base, letting the Saw Blade do the
cutting. DO NOT apply excessive force
or serious personal injury, death and or
serious damage to the saw can occur.
Keep your body and any objects
out of the path of the sparks
which will be ejected at high
velocity from the rear of the saw!
FIG. 9
FIG. 10
FIG. 11
✓
Locking
Pin
Trigger
Trigger Safety Lock
✓
✓
