10
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
FIG. 12
FIG. 13
FIG. 14
FIG. 15
BLADE REPLACEMENT
• Unplug the Saw.
• Raise the Saw by pushing down on it
and pulling out the Locking Pin located
at the lower left side of the motor
mount, just below the pivot
(FIGS 9 & 10)
.
• Move the Shaft Guard Plate out of
the way by loosening the two 10 mm
retaining nuts and rotating it up out of
the way
(FIGS 12 & 13)
.
• Retract the lower half of the Blade
Safety Guard against spring pressure,
up and fully into the upper half of the
Safety Guard. This will expose a hole
that the Armature Lock Pin must fit
through before passing through,
contacting and locking the motor
armature
(FIG 14)
.
• Continue to push the Armature Lock
Pin lever located on the underside of
the motor
(FIG 15)
, inward towards
the Blade while rotating the Blade
slowly until the Lock Pin snaps into a
detent locking the motor armature and
preventing it from rotating.
Unplug Saw from electrical
supply before changing blade!
Slotted Hole
✓
Pin
✓
✓
10mm
Nuts
✓
Shaft Guard
Plate
✓
✓
Armature
Lock Pin
✓
Blade
Safety
Guard
✓
