6
Eastwood Technical Assistance: 800.544.5118 >> [email protected]
FIG. 4
FIG. 5
SWITCHING JAWS
The Upper and Lower Shrinker and Stretcher Jaws
[C] [D]
are retained by (4) Socket Head
Cap Screws and washers each.
REMOVE JAWS FROM BODY (FIG 4)
1.
Loosen (Do Not Remove) Upper Jaw Cap Screws (2 per side) with a
4mm Hex Key (not Included).
2.
Pull Upper Jaws away from Body and slide Wire Bail off the Actuating Bar.
3.
Loosen Lower Jaw Cap Screws (Do Not Remove) (2 per side) with a
4mm Hex Key (not Included).
4.
Pull Upper Jaws away from Body.
ATTACH JAWS TO BODY (FIG 5)
1.
Slide Lower Jaws onto Body with screw slots located under Cap Screws and Washers.
2.
Tighten Lower Jaw Cap Screws with a 4mm Hex Key (Not Included).
3.
Slide Upper Jaws onto Body with screw slots located under Cap Screws and Washers.
Place Wire Bail over top of Actuating Bar.
4.
Tighten Upper Jaw Cap Screws with a 4mm Hex Key (Not Included).
STORAGE
1.
Remove Handle for safety.
2.
Apply a thin film of light oil or rust-preventive to all bare steel areas.
3.
Store in a clean, dust-free, dry, dampness free area preferably covered
with plastic sheeting.
MAINTENANCE
NOTE
: Maintenance should be performed before each use.
1.
Clean dirt and debris from Jaw Gripping Teeth.
NOTE:
Forming aluminum will cause a buildup of aluminum in Gripping Teeth. They must be cleaned with a wire brush periodically when
working with aluminum.
2.
Check tightness of all hardware.
3.
Check operation for binding. Lubricate sliding parts and pivot points periodically with medium bodied oil.
NOTE:
Use care to avoid getting oil on Jaw Gripping Teeth.
