EASTMAN PACEMAKER, Инструкция по эксплуатации и иллюстрированный список запасных частей

Страница: 3 / 44

3
The Eastman PACEMAKER is shipped with all the neces-
sary parts for proper setup and operation. To get the best
performance, familiarize yourself with all functions and
adjustments of this equipment. Before any operation can
take place, it is important that you carefully read and follow
the instructions in this manual in the same sequence in
which they are presented.
The following items listed below may be included with your
installation kit or purchased at a later date:
MS- Machine size in Inches.
*: Optional Equipment.
F-218 C-Clamps (2)
F-261-T T-Track (50'-0")
PM-0213-MS *Flat Fold Platform
PM-0216 *Triangle Attach., Stationary
PM-0217 *Triangle Attach., Movable
PM-02238-MS *Frozen Bar
PM-02243-MS *Mast
PM-03078 *Roll Aid
PM-0401 *Tricot Uprights
PM-0404-MS Movable Catcher
PM-0405-MS Stationary Catcher
PM-04132-MS *Heavy Duty Expandabar
PM-158 *Stationary Catcher Extension
PM-159 *Movable Catcher Extension
PM-1004-MS Expandabar with Shifter
TA-3002, TA-3003 *Premium Track Chairs
TC-1, TC-2 *Plastic Track Chairs
11-2000-voltage *Trolley
205-34 Hex Nut (4)
301-14-20 Wood Screw (4)
331-34-32 Hex Bolt (4)
402-34 Lock Washer (4)
410-34 Flat Washer (4)
9136-001 Allen Wrench Set
INSTALLATION
Table Preparation
Spreading table must be at least six inches wider than
machine size.
The spreading table must be smooth and level, along its
entire length, for proper operation of your Pacemaker. A
level table with properly attached tracking is the single
most important factor affecting the performance of your
spreader.
To Level Table
Use a carpenter's level to check spreading table. Be
especially careful to make sure table joints mate closely.
Adjust levelling feet, on table legs, as necessary.
Track Installation
Note: The methods for mounting "T" track and gear track
are identical as follows:
Lay track sections along table top, end to end, in the
locations they will be mounted. Make sure that joints in
track DO NOT align with seams in table.
Note: If roll weight will exceed 200 lbs. (91kg), premium
track chairs should be used (TA-3002, TA-3003).
Premium Track Chairs
Starting at center section of tracking, drill 1/4" dia. holes
into skirt of table, 3/4" down from top surface of table. Use
included hardware to mount double track chairs (TA-3003)
at track joints and single track chairs (TA-3002) at interme-
diate mounting holes.
Plastic Track Chairs
Starting at center section of tracking, drill 1/4" dia. holes
into edge of table top. Use included hardware to mount
double chairs (TC-2) at track joints and single track chairs
(TC-3) at intermediate mounting holes.
Mounting Track
Loosely screw tracking onto track chairs. Align track edge
slightly below top surface of table, to avoid interference
with cutting machine base plate. Tighten track, making
sure all joints mate closely and tracking is level.
From
the
library
of:
Diamond
Needle
Corp