EASTMAN Kodak X-Omat 180 LP, Руководство по обслуживанию

Страница: 58 / 134

SERVICE MANUAL
2–16 July 1995 – 1C7833
Replacement of the IDLER ROLLERS and SPRINGS on a MODULE
Figure 2–17
Replacement of the IDLER ROLLERS
on a MODULE
[1] Remove the MODULE. See Page 2–11.
[2] Use a small SCREWDRIVER to press down on
the SPRING to remove it from the groove in the
SHAFT.
[3] Move the SHAFT toward the smaller end of the
SHAFT until the larger end is removed from the
SHAFT SUPPORT.
[4] Tilt the ROLLER until the larger end of the
SHAFT is above the SHAFT SUPPORT.
[5] Remove the ROLLER from the SHAFT.
[6] Remove the SHAFT.
[7] To remove the SPRING, pull it up from the LIP.
[8] Reverse the steps to install new ROLLERS or
SPRINGS.
[9] Check that the SPRING is between the LIP and
the MODULE and in the groove on the SHAFT.
[10] If necessary, remove other components on the
MODULE and install new components. See
Pages 2–11 through 2–14.
[11] Reverse the steps on Page 2–11 to install the
MODULE in the SORTER.
Note
You can use a piece of paper wrapped around the new
ROLLER to hold the ROLLER in position during
installation.
H127_2024CA
H127_2024CCA
groove
end
smaller
paper
LIP
ROLLER
SHAFT
SPRING
MODULE
SHAFT
SUPPORT