Form C-1572
Adjusting the Belt Sharpener
Note:
You can obtain all the special tools you will require
for adjusting the sharpener by ordering tool kit #820C2.
O rear pulley
T
front pulley
S
slide with pulley
U sharpener shoe
Figure 5. Changing the Sharpener Belts
WARNING
Failure to unplug the attachment plug from the power
source before performing maintenance may result in se-
rious personal injury.
Changing Sharpener Belts
1. Push the slide with pulley (Figure 5, S) inward to relieve
tension, then remove the worn belt.
2. Place the new belt over the front pulley (Figure 5, T),
then between the sharpener shoe (Figure 5, U), and
then over the rear pulley (Figure 5, O).
3. Release the slide with pulley.
Note:
Sharpener belts are available in four grits: Rough,
Coarse, Medium, and Fine. See
Abrasive Belt Grits
on
pages 17-18 for ordering information.
Adjusting Stabilizers for Central Alignment
1. Disengage the attachment plug, if you have not already
done this.
2. Depress the sharpener lever (Figure 2, E on page 3)
halfway and lower the belt carrier to the extreme bottom
position.
3. Loosen the screws (Figure 6, 1) and disengage the
back guide (Figure 6, 6) from contact with the standard.
4. Loosen the screws (Figure 6, 2) and disengage the
stabilizers (Figure 6, 4 and 5).
1
screw
9 locknut
2
screw
10 clamping arm
3
locknut
11
sharpener shoe
4
stabilizer
12
shoe
5
stabilizer
13
tube
6
back guide
14
spacer
7
pivot screw
15 locknut
8
stop screw
Figure 6. Adjusting the Stabilizers
T
U
S
O
7
