Eastman Outdoors 38245, Инструкции и уход

Страница: 14 / 16

13
Stuffing Casings for Brats, Sausages and Hot Dogs
Lay out the casing in front of the Grinder Housing and place one end
of the casing over the stuffing nozzle. Place your already ground and
marinated meat into the Hopper Tray. Plug in the Grinder and then
press the ON / OFF Switch to turn on the Grinder. Use the Food Pusher
to gently press the ground meat into the Grinder Housing. Do not press
so hard as to stall the grinder. Allow the meat to be dispensed into the
casing and as the casing fills with meat to your desired sausage, brat or
hot dog length then press the ON / OFF Switch to turn off your Grinder.
Then twist the casing several times to lock the meat in the casing to your
desired length. Turn the Grinder back on to fill another length of casing
and repeat the twisting procedure to lock the meat in the casing to your
desired length until the full length of casing is filled with meat.
Filling Food Storage Bags
Place the Large Food Storage Stuffing Nozzle on the machine over your
chosen cutting blade and attach with the Locking Nut. The nozzle will
quickly your Food Storage Bags for later use.
Clearing Jams
There is a safety feature built into your Electric Meat Grinder that will
automatically disconnect power if a jam occurs. Should this happen,
immediately unplug the machine. Allow a minute or two for the machine
to cool down and reset. Plug in the unit and press and hold the REV
button to clear the jam. Release the REV button. When the motor
stops, unplug the unit. Remove the Locking Nut, the Cutting Plate
and the Cutting Blade and remove the debris that has caused the jam.
Once the jam is cleared reassemble the unit, plug it in and begin normal
operation again. The unit is built with an automatic shut-off in case of an
overload. If the unit shuts off automatically turn the unit off, unplug it, and
clear the food from the grinder. Wait a few minutes for the unit to reset
and then reassemble and use per instructions.
Disassembly
Be sure that the unit is turned off and unplugged before disassembling.
Remove the Locking Nut, Cutting Plate and Feed Screw. To remove
the Grinder Housing, press the black button on the Main Housing next
to the Grinder Housing and turn the Grinder Housing clockwise to the
“UNLOCK” position. Remove the Grinder Housing.
Cleaning
After use, turn the Grinder off and unplug from the wall outlet. Remove
the Locking Nut, Cutting Plate, Cutting Blade, Feed Screw and Grinder
Housing. Wipe the Main Housing with a damp cloth and dry thoroughly.
Wash the remaining items in hot, soapy water and dry thoroughly. The
Cutting Plates and Blade are stainless steel and may be washed in the
dishwasher. The plastic Nozzles can also be washed on the top rack
or using a no heat setting. No other parts should be washed in the
dishwasher. For storage you can apply a light coat of vegetable oil to
any or all of the metal parts.